| Author |
Message |
Fox
Guest
|
 Posted:
Mon May 02, 2005 7:25 am Post subject:
Before Maxtor 6YL0... now CALYPSO |
|
|
I have two HDD MAXTOR DIAMONDMAX PLUS 9 80GB
They worked always fine.
But from one day to another the two HDDs showed the same problem, almost
simultaneously.
Whereas before the BIOS recognized them as MAXTOR 6Y080...., now PC does not
start, and entering the BIOS - with many diffulties - they are recognized as
CALYPSO, whitout any other information.
I tried to use Powermax or Maxblast, but on the primary IDE there is not any
HDD.
The same if I connect the HDD to secondary IDE.
On the same PC I am using other Maxtor HDDs, without problems.
On the WEB I read that many pepole had the same problem, due to the fact
that HDDs lost firmware.
It is possible to restore the firmware on HDDs? Thare is any software to do
it?
Thanks |
|
| Back to top |
|
 |
John@Smith.com
Guest
|
| Posted:
Mon May 02, 2005 7:25 am Post subject:
Re: Before Maxtor 6YL0... now CALYPSO |
|
|
| Have you tried them on another motherboard? |
|
| Back to top |
|
|
Fox
Guest
|
| Posted:
Wed May 04, 2005 7:25 am Post subject:
Re: Before Maxtor 6YL0... now CALYPSO |
|
|
| Yes, but it is the same. |
|
| Back to top |
|
|
John@Smith.com
Guest
|
| Posted:
Wed May 04, 2005 7:25 am Post subject:
Re: Before Maxtor 6YL0... now CALYPSO |
|
|
You know this sounded like a weird problem so I looked it up and a few
people who claim the firmware changed and has similar problems like
you -------the responses say no way could it do that.
And others say you cant flash the firmware from your PC.
Have you tried running the powermax diagnostic program to zero out
your Hard disk from a different PC? Or using FDISK you know DOS
utilities and FIX MBR in the recovery console mode? Maybe even
spinrite. Also try manually putting in the parameters for your HD in
the bios. |
|
| Back to top |
|
|
Autumns_Burning
Joined: 09 Apr 2006
Posts: 1
|
| Posted:
Sun Apr 09, 2006 12:45 am Post subject:
|
|
|
| SO I have the same HDD (120GB) and mine has done the same thing...but it started clicking, so I figured it was over-heating/ needed dusting, so I dusted it it and now I have it hooked up externally and it doesn't click like it used to...before it was every other second...now it does it twice over the period of a few minutes, and then it stops...but it still isn't showing up, other than in Device Manager and it shows up THERE as Calypso:(. I thought it may be drivers, but I can't find any Maxtor drivers for this HDD online, and I have no idea where the disk is that came with it:( Any ideas? |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in
